| Parameter |
Associated MIB variable |
Description |
| BIA |
cpsmp100BiaIndex(1) |
See BIA and Slot |
| Slot |
cpsmp100SlotIndex(2) |
See BIA and Slot |
| Group Membership |
cpsmp100Groups(3) |
See Configuration Management |
| Marketing Revision |
cpsmp100MRevision(4) |
Marketing Revision |
| Config Match |
cpsmp100CfgMatch(5) |
Configuration Management match? |
| Serial Number |
cpsmp100SerialNumber(6) |
Serial Number reported by hardware |
| Mode |
cpsmp100Mode(7) |
Master/Slave/Shared Mode of this supply |
| Configuration Mode |
cpsmp100ConfigMode(8) |
Configuration Mode |
| Remote Fan |
cpsmp100RemoteFan(9) |
A Remote Fan is a device that fits in a power supply slot but contains no power supply, only a fan. These devices are not manageable, but if present they will be reported by the manageable supply that accompanies it. |
| Power OK |
cpsmp100PowerOK(10) |
This variable has the value yes(1) any time this supply is capable of supplying at least 11.6 volts to the cabinet. Note that a value of no(2) does not necessarily indicate hard failure. A power supply can be detected even if it is powered down or not plugged in as long as another power supply has PowerOK=yes(1) and InUse=yes(1). In this case, PowerOK will be no(2) for the disabled power supply. |
| In Use |
cpsmp100InUse(11) |
Value is yes(1) when this supply is currently selected to supply power to the cabinet. |
| Chassis Power |
cpsmp100ChassisPower(12) |
Power currently supplied to the cabinet, in milliwatts |
| Chassis Temperature |
cpsmp100ChassisTemp(13) |
The temperature inside the cabinet as detected by the power supply, stored in tenths of degrees centigrade but usually converted to degrees for display. |
| Remote Fan Fault |
cpsmp100RfanFault(14) |
Normally no(2), this value changes to yes(1) when an installed Remote fan is drawing excessive current or none at all. |
| Local Fan Fault |
cpsmp100LfanFault(15) |
Normally no(2), this value changes to yes(1) when the Local fan is drawing excessive current or none at all. |
| Supply Type |
cpsmp100SupplyType(16) |
The supply voltage that this unit is designed to accept. IfAC(1), the supply accepts 90-260VAC, 47 to 400Hz. IfDC48(2), the supply accepts 38-75VDC. |
| Cache Clean |
cpsmp100CacheClean(17) |
Configuration changes pending? |
