| Parameter |
Associated MIB variable |
Description |
| BIA |
cetct100BiaIndex(1) |
See BIA and Slot |
| Slot |
cetct100SlotIndex(2) |
See BIA and Slot |
| Group Membership |
cetct100Groups(3) |
See Configuration Management |
| Marketing Revision |
cetct100MRevision(4) |
Marketing Revision |
| Config Match |
cetct100CfgMatch(5) |
Configuration Management match? |
| Serial Number |
cetct100SerialNumber(6) |
Serial Number reported by hardware |
| Configuration Mode |
cetct100ConfigMode(7) |
Configuration Mode Some variants of the CETCT100 have no software configurable features, and thus are always in “hardware” mode. |
| Firmware Revision |
cetct100FirmwareRevision(8) |
Firmware Revision of the switch |
| Twisted Pair Link |
cetct100TPLink(9) |
Link status of Twisted Pair Port |
| Collision |
cetct100Collision(10) |
This status variable indicates whether or not an Ethernet collision occurred during the most recent polling cycle. |
| Coax Activity |
cetct100CoaxActivity(11) |
This status variable indicates whether or not Ethernet traffic was detected on the Coax interface during the most recent polling cycle. |
| Twisted Pair Activity |
cetct100TPActivity(12) |
This status variable indicates whether or not Ethernet traffic was detected on the Twisted Pair interface during the most recent polling cycle. |
| Collisions (previous minute) |
cetct100CollisionsPerMinute(13) |
The number of Ethernet collisions that occurred during the most recently completed measured minute. Every 60 seconds, the device moves its previous collision count into this variable, and restarts the counter at zero. |
| Collisions (previous hour) |
cetct100CollisionsPerHour(14) |
The number of Ethernet collisions that occurred during the most recently completed measured hour. Every 60 minutes, the device moves its previous collision count into this variable, and restarts the counter at zero. |
| Twisted Pair Connector |
cetct100ConnA(15) |
Connector Type reported by device |
| Coax Connector |
cetct100ConnB(16) |
Connector Type reported by device |
| Cache Clean |
cetct100CacheClean(17) |
Configuration changes pending? |
