A5135-H

The A5135-H will track and follow GPS and GLONASS systems concurrently

The A5135-H is a high-sensitivity concurrent GNSS antenna receiver that integrates Qualcomm’s SiRFstar V technology into a single, compact and easy to integrate SMT device.

By supporting simultaneous GLONASS, GPS, QZSS and SBAS measurements with the industry’s best sensitivity engine, the highest accuracy, ground tracks and fastest time-to-first-fix (TTFF) are ensured even under tough operating conditions.

Product Highlights

Concurrent GNSS receiver
Pin-to-pin compatible with A2135-H / A2235-H
Lowest tracking power consumption
Download SiRF Live

Key Markets

A5135-H Overview

Concurrent GNSS receiver The A5135-H will track and follow GPS and GLONASS systems concurrently. Dual reception of GPS and BeiDou or even concurrent GLONASS and BeiDou reception is still possible by setting up the parameters. Our fine tuned signal reception and sophisticated software algorithms improve availability and accuracy in urban canyon environments.
Pin-to-pin compatible with A2135-H / A2235-H This A5135-H is pin-to-pin compatible with Lantronix A2135-H / A2235-A. Power, ground and dedicated pins are at the same location across device densities in order to adapt to your current design.
Lowest tracking power consumption SiRFaware’s advanced low power management modes, high level of integration and multiple communication ports in a small form-factor makes the A5135-H suitable for a broad spectrum of GNSS applications where performance, cost and time to market are prime considerations.
Download SiRF Live Test the performance of Lantronix GNSS receivers and develop your application with SiRF Live software. Download here

A5135-H Tech Specs

PERFORMANCE

HIGHLIGHTS

Channels	52
Frequency	GPS LI – 1,575 MHz GLONASS – 1,602 MHz
Sensitivity1	GPS	GLONASS
Tracking	– 165 dBm	– 163 dBm
Navigation	– 160 dBm	– 159 dBm
Acquisition (cold start)	– 147 dBm
Position Accuracy2) (horizontal)	< 2.5 m CEP (autonomous) < 2.0 m CEP SBAS
Time To First Fix
Hot Start2)	< 1 s
Warm Start2)	< 30 s
Cold Start2)	< 35 s
Navigation
Update Rate	1 Hz / 5 Hz Supported

SiRFnavTM	High availability and coverage; improved TTFF in weak signal environments
SiRFawareTMTM
Jammer remover technology	Detects and removes up to 8 in-band jammers with minimal loss of sensitivity
A-GPS	Embedded Extended Ephemeris (SiRFInstantFix) and Ephemeris Push support
MEMS I2C interface	Prepared to use additional sensor information for improved navigation

COMMUNICATION

POWER CONSUMPTION GPS + GLONASS

UART – OSP
Open Socket Protocol	Protocol extension for SiRFstarV
Baud rate Switchable	115.2k (default) 1,200 to 115.2k
Ports	Tx (Binary output) Rx (Binary input)
UART – NMEA (default)
NMEA message Switchable	GGA, RMC, GSA, GSV, VTG, GLL, ZDA
Baud rate Switchable	1,200 to 115.2k Default 9600
Ports	Tx (NMEA output) Rx (NMEA input)

Supply voltage	3.0 to 3.6 VDC
Average Current Draw	(typical)
Full power mode (Searching) Peak Current	42mA
Full power mode (Searching) Average Current	36mA
Full power mode (Tracking) Average Current	31mA
Trickle Power Mode	29mA
Hibernate Status	27uA

MECHANICAL

ENVIRONMENT

Dimensions
L x W x H	17.78 x 16..01 x 2.5 mm
L x W x H	0.7” x 0.65” x 0.1”
Weight	4 g / 0.14 oz.

Temperature
Operating	-40°C to +85°C
Storage	-40°C to +85°C
Humidity	Non condensing

A5135-H Downloads

User Guides

GNSS Receiver Module A5135-H User Guide Rev E

1 MB

View

Product Notifications

You must log in or create a MyLantronix account to view product change notifications.

A5135-H Part Numbers

Lantronix Part #	Name	Description	Order Now
Sorry, no parts were found that match that search query.
GNS Receivers
Lantronix Part # A5135H	Name GNSS	GNSS A5135H - SiRFstarV-based 52-channel GNSS receiver built-in patch antenna, -147 dBm acquisition sensitivity, -160 dBm navigation sensitivity, I²C MEMS interface	Buy Now