The SISPM1040-384-LRT-C is a managed PoE+ switch suitable for connecting and powering devices in hardened environments. The switch can supply up to 30 Watts per port on all (8) ports simultaneously. The switch also includes the embedded Device Management System software that provides the advanced tools necessary for total management of all IP addressable devices. The unique DMS provides security integrators with lower overall cost, less downtime and easier management of the entire PoE+ network.
Lantronix’ hardened switches are certified to operate reliably in harsh environments such as those found on factory floors, outdoor enclosures or other challenging environments.
Store-and-Forward Architecture with 24 Gbps Switching Bandwidth
Supports Jumbo frames up to 9.6K Bytes
Industry standard G.8032 Ethernet Ring Protection Switching (ERPS)
Support G.8031 Ethernet Linear Protection Switching (EPS)
Rapid Ring with recovery time less than 20ms
Supports LLDP Protocol
Temperature Detection and Alarm
Support HW Watchdog to resume operation from CPU hang up
IEEE 1588 v2 PTP
Auto Power Reset (APR)
DHCP per Port
Always on PoE
Complies to IEEE 802.3at, IEEE 802.3af
IEEE 802.3ad LACP, up to 6 groups and up to 4 ports per group
Up to 4K VLAN groups, Port based, IEEE 802.1Q tag, Q-in-Q, MAC based VLAN, Management VLAN, Private VLAN Edge, Voice VLAN, GVRP
ACL – up to 256 entries, Drop or Rate limiting based on: Source and Destinations MAC, VLAN ID and IP address, protocol, port, DSCP/ IP precedence, TCP/UDP source and destination ports, IEEE 802.1p priority, Ethernet type, ICMP packets and TCP flag
Quality of Service
Supports 8 hardware queues
Scheduling: strict priority and WRR, Queue assignment based on DSCP and class of service
Classification: Port based, IEEE 802.1p VLAN priority based, IPV4/IPV6 precedence / DSCP based, DiffServ, Classification and re-marking ACLs
Rate limiting: Ingress policer, Engress shaping and rate control, per port
To achieve approval, a vendor must undergo an evaluation of their internal quality system based on the ISO 9001 standard, which is followed by a product evaluation. Successful applicants have their product listed on the Florida DOT Approved Product List (APL).
The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.